Voldemort's wand has been finished!
After a great deal of time spent on gethering information on the wand we had everything to begin. Basic infos and sizes came from the Official Harry Potter Wiki page, of course. We used pictures from other replicas and screen caps as inspiration.
After the model was done. It had to be sliced to smaller pieces. Tom Riddle's wand was 13 1/2"(34.29 cm) in length which would have been too much for our Reprap's plate. The wand was devided to 2 sides and each side was devided to 4 parts. 8 long parts are too much for one plate. The pringing would have been too long in one run anyway. They were printed in a couple of sessions.
We used our favorite acrylic paint. We used more layer of paints to get the best result. Two layes of waterproof finnish were used to protect the wand. It was designed to be display, but it could be used as a toy.
Finally the wand was ready. We were always wondering why Voldemort was holding his wand so strangly, so unnaturally. When we holded it in our hands we'd found the answer. Even for a small hand there was no good grip on it.